1W Developed led cap lamp underground mining with OLED screen
|Mian light Power||1W||back up lighting time||100H|
|illuminance||15000 Lux||battery capacity||6.6A|
|input voltage||AC100-240V||battery voltage||3.7V|
|output voltage||DC5V||battery charging time||<8h|
|output Current||1.5A||Life span||1000circle|
|high bright lighting time||13H||LED||Cree XP-E2|
|mid bright lighting time||26H||Screen||OLED|
1 Product Discription:
1 With cree XP-E2 LED the light was has a high brightness.
2 Inductive charger used can avoide the oxidaton of charging port.
3 OLED screen adapted. It has a better shock-resistance feature and
can be used under -40℃.
energy cost is also lower than LCD screen
4 The angle of clip is less than usuall items, which makes the
center of gravity more closer to helmet.
So people who wear it will feel more cozy.
2 charger connection:
1. Refer below 'figure 1' to put the lamp on the charger, and align
the line on lamp to the centre line
2. Slide the lamp as the 'close' direction to lock the lamp with
charger well, refer 'figure 2'.
3 operation instruction
1. Press display switch to turn on/ off OLED display.
2. Press lamp switch first time for main light high brightness;
Press lamp switch second time for main light half brightness,
Press lamp switch third time for backup light.
3.When in any time, press and hold the lamp switch for three
seconds, the main light will start flashing.
4.Time and serial number setting:
Press both display switch and lamp switch at the same time for
three seconds, the lamp turn to time and
serial number setting mode. "Setting" will be shown on the right of
the second line of OLED display, and
the digit of "hour" start flashing at the same time,
Then press lamp switch to set the number of “hour”. After that
press display switch, the digit of “minute”
start flashing, press lamp switch to set the number for “minute”.
Repeat the above steps to set the numbers of weeks, date and lamp’s
It will be out of the setting mode if no operations was done within
1 Light source: 1W led 2 Back-up light: 2pcs 3014 SMD led
3 lamp switch 4 display switch.
5 OLED display: to show lamp serial number, time, battery balance
and working mode,
6 Mounting clip 7 Induction coil